
Spring applied brake with all metric interfacing dimensions. Slots on the back fit into tabs mounted on the machine to react brake torque while conserving space.
Products
Spring applied brake with all metric interfacing dimensions. Slots on the back fit into tabs mounted on the machine to react brake torque while conserving space.
At just 1.75 inches thick, this air applied brake provides tension control in a narrow space on a coil winding machine.
Compact brake used on an assembly fixture attaches to a 5/8 inch shaft with a shrink disc instead of a key and set-screw.
Air applied brake has an enclosed design and provides tension on film in a food packaging application.
Fits between a Dyna-Torque 7 air motor and a gear reducer with an IEC 100-B5 flange. Holding torque capacity is 274 pound inches.
Air applied brake provides ultra-light tension on a half-inch shaft and is less than an inch and a half long.
Spring applied brake holds a 19 mm shaft stationary until it is disengaged with compressed air or, in case of a power outage, manually disengaged with the release lever.
With four brake discs, this spring applied brake holds a 1.75 inch shaft with 4,400 pound inches of torque and fits within a 9 inch diameter.
Required to have a torque capacity of nearly 4,000 pound inches within a diameter of less than 5.5 inches, this unit delivers with a multi-disc design.
This torque limiter locks onto the shaft with a shrink disc and includes an integral 60L100 pulley. It replaced a Browning TGC 60 on a retrofit project.