Clutch/Brake Combination Application Information

Contact Information

Please provide as much information as possible. We will be happy to assist you with questions: 859-291-0849

Specifications

1. Clutch/Brake is needed for:

New Machinery
Retrofit - to replace (Mfg., Model, Etc):

* 2. Clutch/Brake Mounting:

End of Shaft
        Shaft Size (specify inches / mm):
        Keyway (specify inches / mm):
Thru-Shaft (with reaction/torque arm)
        Shaft Size (specify inches / mm):
        Keyway (specify inches / mm):
Coupling Two Shafts
        Drive Shaft Size (specify inches / mm):
        Drive Shaft Keyway (specify inches / mm):
        Driven Shaft Size (specify inches / mm):
        Driven Shaft Keyway (specify inches / mm):
Nema Frame (C-Face)
        Frame Size:

3. Clutch/Brake Configuration: Clutch/Brake will... * Required if Clutch/Brake Mounting is End of Shaft or Thru-Shaft

Stop & Start the Shaft
Start and Stop the Sprocket(s)

4. Sprocket Requirements: * Required if Clutch/Brake Mounting is End of Shaft or Thru-Shaft

Single
Double

Chain Size: # of Teeth:

5. Input Source:

Electric Motor
Gas Engine
Diesel Engine

HP: RPM:

* 6. RPM at Clutch:

* 7. Cycle Rate (X per Minute):

* 8. Required Torque
        Clutch(specify lb.in / lb.ft / Nm):
        Brake(specify lb.in / lb.ft / Nm):

9. Inertia of the Load (specify lb.ft² / kg.m²):

10. Operating Air Pressure Restrictions (if any):
        Minimum (PSI): Maximum (PSI):

11. Envelope Restrictions (if any):
        Maximum Length (specify inches / mm):
        Maximum OD (specify inches / mm):

Additional Information
Please include any special requirements, environmental conditions, etc.